Setelah proses washing, air kan sudah kotor dan dibuang. Setelah itulah yang dinamakan proses rinse atau pembilasan dengan air baru. Sedangkan yang dimaksud proses spin adalah proses pengeringan setelah tahap rinse atau tahap pembilasan tadi. Masalah Mesin Cuci Tidak Bisa Rinse dan Spin. Terkadang muncul berbagai problem saat melakukan proses I'm having same problem as my machine will start agitating at initial fill and rinse as spin is completing and then stop (this is on normal wash) also extra rinse is turned off. It does the initial fill and agitate at the same time on Casual wash but does not do the rinse after spin so now I just use Casual wash. The machine turns on. Press the Start/Pause button to activate “Calibration Mode”. The pulsator rotates clockwise and counterclockwise for approximately 1 minute. When “Calibration Mode” is finished, “End” or"CB" appears on. the display, and the machine automatically turns off. The rinse cycle is an important part of the washing process. It helps to clean your clothes and get them ready for the dryer. When you run a load of laundry, the washer goes through several different cycles in order to clean your clothes. The first one is called the prewash cycle, and it is used to loosen up any dirt or stains on your clothes Perform Rinse Mix Chamber Go to Dx Tools>VCSn tab, select Fluidic>Rinse mix Chamber>Start. If not resolved, proceed to next step. Perform in order, as needed: - Flush Flow Cell (no cleaner) Go to Dx Tools>Maintena nce tab, select Flush - Flow Cell.>Choose ‘Both’>Start (repeat 5x) - Repeat Flush Flow Cell with Cleaner for 5 Spin. Dalam mekanika kuantum, spin adalah momentum sudut intrinsik yang berhubungan dengan partikel. Sebagai contoh, partikel dasar seperti elektron, mempunyai momentum sudut dari spin, sekalipun mereka (untuk maksud lain) adalah seperti partikel titik. Partikel subatomik lainnya, seperti Neutrino, yang tidak mempunyai muatan listrik, juga .

rinse and spin adalah